Table of Contents
Advertisement
Chapter 10 Waveform Record
during the playback process.
5. End Frame
Press this softkey and use
is the total number of frames of the waveform recorded.
6. Playback Operation
Waveform playback can be realized through the menu or the shortcut buttons
on the front panel.
Menu
Press Operate and select "
to start playing back.
Press Operate and select " " to
pause the playback.
Press Operate and select "■" to
stop the playback.
7. Time Tag
The time tag is used to display the absolute recording time of each frame of the
waveform currently recorded. Press Time Tag to enable or disable the time tag
function. When it is enabled, the time tag information is displayed at the upper
right corner of the screen as shown in the figure below.
△T: display the recording time deviation of the current waveform relative to the
T
: display the absolute starting time of the waveform record.
0
first frame of waveform. This value changes accordingly during the waveform
playback process.
Tip
During waveform playback, RUN/STOP can be used to switch between playback
and pause. Each time SINGLE is pressed, the Current Frame moves one frame
forward.
DS2000E User's Guide
to set the end frame of the playback. The default
Front Panel
Press
; the backlight flashes,
"
indicating that the playback is started.
Press
again (the backlight goes on
(yellow)) to pause the playback.
Press
to stop the playback.
RIGOL
10-7
Advertisement
Table of Contents
