Table 1-2. Mvme6100 Jumper And Switch Settings - Motorola MVME6100 Installation And User Manual

Table 1-2. MVME6100 Jumper and Switch Settings

Jumper/
Switch Function
J7 SCON Header
J10, PMC/IPMC Selection Headers
J15–J18,
J25–J28
J30 Front/Rear Ethernet and
Transition Module Options
Header
S3 SROM Configuration Switch,
sets board Geographical
Address
S4 Flash Boot Bank Select
Configuration Switch, sets
Write Protect A, Write Protect
B, Boot Bank Select, and Safe
Start
Note Items in brackets are factory default settings.
Chapter 1 Hardware Preparation and Installation
Settings
[No jumper installed] Auto-SCON
1-2 Always SCON
2-3 No SCON
[Jumper installed]
1-2 PMC I/O
[2-3] IPMC I/O for IPMC7xx
support (default)
Refer to Front/Rear Ethernet and Transition Module
Options Header (J30) on page 8
Refer to SROM Configuration Switch (S3) on page
8 for details.
Refer to Flash Boot Bank Select Configuration
Switch (S4) on page 9 for details.
MVME6100 Installation and Use (V6100A/IH2)
for details.
5