Dc Under Volt; Batt Chg. Overcur - Huawei Telecom Power TP48200A-DT19C2 User Manual

TP48200A-DT19C1, TP48200A-DT19C2,
TP48200A-HT19C1 and TP48200A-HT19C2 Telecom
Power
User Manual


Measures
1.
2.
3.

4.2.5 DC Under Volt

Possible Causes





Measures
1.
2.
3.
4.
5.

4.2.6 Batt Chg. Overcur.

Possible Causes



Measures
1.
Issue 03 (2019-11-15)
The power system voltage has been manually set to a very high value.
Rectifiers are faulty.
Check whether the DC overvoltage alarm threshold (58 V DC by default) is correctly set.
If not, set the threshold to the correct value.
Check whether the system voltage has been manually set to a very high value. If so,
check with other maintenance personnel whether the voltage can be changed to a normal
value.
Remove the rectifiers one by one and check whether the alarm is cleared. If the alarm
still exists, reinstall the rectifier. If the alarm is cleared, replace the rectifier.
An AC power failure has occurred.
The DC undervoltage alarm threshold is incorrectly set on the SMU.
The system configuration is incorrect.
The power system voltage has been manually set to a very low value.
Rectifiers are faulty.
Check whether an AC power failure has occurred. If so, rectify the fault to restore the
AC power supply.
Check whether the DC undervoltage alarm threshold (45 V DC by default) is correctly
set. If not, set the threshold to the correct value.
Check whether the load current is greater than the present power system capacity. If so,
expand the power system capacity or reduce the load power.
Check whether the system voltage has been manually set to a very low value. If so,
check with other maintenance personnel whether the voltage can be changed to a normal
value.
Check whether faulty rectifiers have resulted in insufficient power system capacity for
the loads. If so, replace the faulty rectifiers.
Rectifier communication is interrupted.
SMU connections are loose.
The SMU is faulty.
Check whether an alarm has been generated for interrupted rectifier communication. If
so, remove the rectifier, reinstall it, and check whether the alarm is cleared. If the alarm
still exists, replace the rectifier.
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
54