Table 2-2: System Modes - Teledyne 300M Instruction Manual

Teledyne API Model 300M CO Analyzer Instruction Manual, 04033, Rev. A

Table 2-2: System Modes

Mode
SAMPLE x (1)
SAMPLE x (1)
ZERO CAL x (2)
SPAN CAL x (2)
MP CAL
SETUP xxx (3)
DIAG DAS (4)
DIAG I/O (4)
DIAG AOUT (4)
DIAG D/A (4)
DIAG TCHN (4)
(1) x = A (auto)
(2) x = M (manual), A (auto), R (remote)
(3) xxx = software revision (e.g. A.9)
(4) diagnostic test modes
The message field shows test measurements or warning messages. Table 2-3 and Table 2-4
summarize the test measurements and warning messages and their meanings. Refer to Sections 4
and 5 for detailed information on viewing test measurements and warning messages and clearing
warnings.
Meaning
Sampling normally
Flashing indicates adaptive filter is on
Doing a zero check or adjust
Doing a span check or adjust
Doing a multi-point calibration
Configuring analyzer (sampling continues)
Data Acquisition configuration
Test digital I/O signals
Test analog output channels
Configure and Calibrate Digital to Analog converters
Configure Test Channel output
2-5