Teledyne 300M Instruction Manual page 44

Teledyne API Model 300M CO Analyzer Instruction Manual, 04033, Rev. A
Example 4: to perform zero check once per day at 10:30 PM and a span check once per week
starting at 11:30 PM, 12/20/93.
1. Select any one of SEQx and program as example 1.
2. Select any other SEQx and program as example.
3. Avoid setting two or more sequences at the same time of the day.
3.5 Summary of Front Panel Check and Calibration
Controls
The calibration controls are summarized below in terms of the button sequences used to access
them.
Table 3-1: Calibration Controls
Button Sequence
CALZ
CALZ-ZERO-ENTR
CALZ-EXIT
CALS
CALS-CONC-ENTR
CALS-SPAN-ENTR
CALS-EXIT
CAL
CAL-ZERO-ENTR
CAL-CONC-ENTR
CAL-SPAN-ENTR
CAL-EXIT
SETUP-ACAL-SEQ1
SETUP-ACAL-SEQ2
SETUP-ACAL-SEQ3
Function
Begin zero check
Adjust CO conc. to zero
Exit zero check
Begin span check
Expected CO span value
Adj. CO conc. to span val.
Exit span check
Begin M-P cal.
Adj. CO conc. zero value
Expected CO span value
Adj. CO conc. to span val.
Exit M-P cal.
Setup auto-cal SEQ1
Setup auto-cal SEQ2
Setup auto-cal SEQ3
3-8
Default Limits
-
-
-
-
400 PPM 1 - 20000 PPM
-
-
-
-
400 PPM 1 - 20000 PPM
-
-
Disabled
Disabled
Disabled
-
-
-
-
-
-
-
-
-
-