Installation Instructions - Assa Abloy Sargent Profile G1 Series Installation Instructions Manual

Profile Series v.G1 Cylindrical Lock
6

Installation Instructions

1. Verify Hand and Bevel of Door
Verify hand and bevel of door
Stand on outside/locked side of the door when determining the door hand
Left Hand
Hinges Left.
Open inward.
"LH"
2. Door Preparation
Prepare door according to appropriate template Lock Body
(see website www.sargentlock.com):
• For metal door template, see 4531 and 4532
Bevel
• For wood door template, see A7456 and A6719D
• Prior to installation, all holes must be free of burrs, debris
and sharp edges
View lock body from top and from the outside (as shown above)
• If doors are not properly reinforced per ANSI115.2,
commercially available reinforcements
should be installed
Hole for ribbon
cable from keypad
to controller
Lockbody
hole
4
800-810-WIRE (9473) • www.sargentlock.com • A7755A
A7755A.indd 4
Left Hand
Reverse Bevel
Hinges Left.
Open Outward
"LHRB"
Latchbolt
Left Hand
Reverse Bevel
Front
Deadbolt
Inside
of door
Latchbolt
Guardbolt
Pre-drill
and/or tap
holes (2)
Wood Door Preparation
Right Hand
Hinges Right
Open Inward.
"RH"
Right Hand
Top
7/8"
C L of
1-1/2" Dia.
1-1/2"
Latchbolt
door prep
Right Hand
Reverse Bevel
Hinges Right.
Open Outward.
"RHRB"
Right Hand
Reverse Bevel
Connector and Wires
(2) 1/8" Dia. holes x 1/4" Deep
required
Lock w/cylinder
Override
(Shown)
Outside
of door
End Cap
Through-bolt
hole (2)
C L of
1-1/2" Dia.
1-1/2"
11/9/18 12:05 PM