Assa Abloy Sargent Profile G1 Series Installation Instructions Manual page 10

Profile Series v.G1 Cylindrical Lock
8. Installation of Outside Escutcheon and Lever
NOTE: For exterior applications, use weather seal gasket part
# (10-0649) between escutcheon and outside door surface
1A. For fire rated doors only feed ribbon cable connector and
ground wire from outside of door through weather seal gasket
(if used) then fire stop plate.
1B. For non-fire rated doors only, feed ribbon cable connector
and ground wire from outside of door through weather seal
gasket (if used), then conduit sleeve in door (not shown).*
2. Slide the outside escutcheon over the lock, and hold
the escutcheon to the door surface
3. Verify white plastic cylinder spacer is inserted into horizontal
slot of lockbody.*
4. Slide the outside lever onto tube with key horizontal
(toward latch). Rotate key 45 degress clockwise.
5. Push lever until lever catch is engaged
9. Inside Escutcheon and Lever
1. Remove black battery cover from the escutcheon with security wrench (provided).
2. Connect ground wire to terminal E3 (Fig. 1), connect keypad harness (Fig. 2) to controller, and connect lock
body motor harness (Fig. 3) to motor connector.
3. Feed all excess wire through inside door hole and/into outside escutcheon cavity, being careful not to pinch
wires.
NOTE: Connectors go on only one way, do not offset connector and be sure they are completely sealed.
4. Insert two #8-32 screws (Fig. 2) through top and bottom of inside escutcheon and thread into outside escutcheon.
Straighten escutcheons and tighten securely, being careful to avoid pinching wires.
NOTE: For RF Technology versions (G1-TU, G1-TP, G1-TA), refer to Section 8 to install through-bolt screws.
5. Slide the Inside Lever onto the tube.
6. Tighten two latch screws completely.
Figure 1
Figure 3
* NOT SHOWN
8
800-810-WIRE (9473) • www.sargentlock.com • A7755A
A7755A.indd 8
Latch
screws
Outside of
door
Weather
seal gasket
Fire stop
plate
Latch
screws
Cylinder
spacer
Inside lever
Outside of
door
Weather
seal gasket
Fire stop
plate
Ribbon
cable with
connector
Weather
Gasket
Cylinder
spacer
Outside
Escutcheon
Ribbon
cable with
connector
(F) Controller
connector
Ground
wire
Inside lever
Weather
Seal
Gasket
Figure 2
8-32 Flat head
screw
(E) Keypad
harness
(F) Controller
connector
(C) Lockbody
harness
Outside
Escutcheon
Ground
wire
Seal
8-32 Flat head
screw
(E) Keypad
harness
(C) Lockbody
harness
(A)
Ground
wire
Inside
of door
Latch
screws
Inside rose
11/9/18 12:05 PM
(A)
Groun
wire
Inside
of doo
Latch
screw
Inside ros