Assa Abloy Sargent Profile G1 Series Installation Instructions Manual page 8

Profile Series v.G1 Cylindrical Lock
5. Lock Installation
Lock Preset to:
• Through-bolt location– 12 & 6 o'clock
• Door thickness– 1-3/4" thick- see below for other door conditions
Adjustment for different through-bolt and door thickness:
• Through-bolt location– rotate outside rose to match door
• Door thickness– rotate outside rose to align door thickness marking with lockbody edge
• Spacer bushing– remove and realign to fit into back of lever
1. Feed wires into the lock body hole, from outside of door.
2. Lock body into cross-bore hole from outside of the door (locked side).
3. Lock body must engage both the latch unit prongs and tail piece, as shown.
For wood
door only
6
800-810-WIRE (9473) • www.sargentlock.com • A7755A
A7755A.indd 6
1-3/4" thick door
2" thick door
Screws partially
tightened
3
Through-bolt
holes
Spacer bushing
Rotate to match
through-bolt holes in door
IMPORTANT:
Door must remain open
during installation.
Use door stop.
IMPORTANT
Lockbody
must be
centered
in the door
11/9/18 12:05 PM