Installation Instructions For Ped5200 Rim Exit Device - Assa Abloy Corbin Russwin IN100 Series Installation Instructions Manual

4

Installation Instructions for PED5200 Rim Exit Device

Prepare door.
a. Verify hand and bevel of door. (Fig. 1)
NOTE: Stand on outside of locked door when
determining door hand.
b. Verify exit device is correct hand for door.
c. Door should be fitted and hung.
d. Verify product label.
e. Mark and drill door. (Fig. 2)
• If mullion is used, install prior to installing
hardware
• Doors should be pre-prepped (recommended)
Prior to installation, all holes must be free of burrs, debris and sharp edges.
Prepare door according to appropriate template (see website).
Field Template (ships with product): MEFT18 (MEFT26 for EA option)
•
• Door Manufacturer's Template (online): MEDT53
• Exit Device Installation Instructions: FM577
NOTE: Instruction examples show wood door installation.
For metal doors, route cables inside door.
Through Bolt
Holes
Through Bolt
Holes
Cylinder Hole
Trim Lever Hole
Trim Through Bolt
Hole
Outside
of Door
Trim Through Bolt
FM592 09/23
Inside
Left Hand
Reverse
LHR
Outside
Fig. 1
Door
Position
Switch
Hole
Fig. 2
10
Copyright © 2016, 2019, 2021-23, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN100 Series
PED5000 Series
Exit Devices
Right Hand
Reverse
RHR
Inside
of Door
Through Bolt
Holes
Through Bolt
Holes
Wire Run Channel
(Wood Door)
Cylinder Hole
Lever Hole
Trim Through Bolt
Hole