Danfoss VLT FC 100 Manual page 51

VLT® FC 100 LonWorks 7. How to access FC 100 parameters
In the [Field List:] under the section [par_number], enter the parameter number (in this example
3-41). If an indexed (array) parameter is accessed, the [subindex] field must be filled-in.
7
130BA454.10
The response may look like this:
Value [0] (1st byte) = 232
Value [1] (2nd byte) = 3
-meaning that the readout value of parameter 3-41 is: 232+(3x256) = 1000
Conversion index of par. 3-41 is: -2(0.01)
Ramp 1 Ramp-up Time = 1000x0.01 = 10 seconds
51
MG.11.E1.02 - VLT ® is a registered Danfoss trademark