Cutter Inspection; Back Printing Head Inspection; Back Printer Head Replacement - FujiFilm SP-3000 Service Manual

2.3 Maintenance and Inspection Procedures

2.3.10 Cutter Inspection

1. Check the edges of prints. If they are rough,
replace the unit with a new one
for the upper cutter or
11.1.12
one).

2.3.11 Back Printing Head Inspection

1. Check the back printing of prints. If it is abnormal,
replace the ink ribbon cassette with a new one
and check the back printing again.
2. If the back printing is still abnormal, replace the
back printer head
(See Subsection 2.3.12)

2.3.12 Back Printer Head Replacement

Removal
1. Open the magazine door.
2. Loosen the screw and move the back printer unit
to the right side. Then retighten the screw.
3. Push the locking tab and remove the ink ribbon
cassette.
4. Remove the screw and then the connector cover.
Distributed by minilablaser.com
(See Subsection
for the lower
11.1.19
.
2-9
Screw
Connector Cover
2
L2928