Printer Adjustment/Maintenance (05); Paper Magazine Feeding Fine Adjustment (0520) - FujiFilm SP-3000 Service Manual

5.6 Printer Adjustment/Maintenance (05)

5.6.1 Paper Magazine Feeding Fine Adjustment (0520)

This menu should be executed for all paper
magazines when installing the machine, or when a
new magazine is registered.
[Selection]
[Setup and Maintenance] → [05 Printer Adjustment/
Meintenance] → [0520 Paper Magazine Feeding Fine
Adjustment]
<Auto Adjustment>
1. Set a new magazine on the upper magazine deck.
2. Select "Upper" for "Magazine".
3. Click the [Print] button.
• After about three minutes, prints 1 and 2 are
output to the sorter.
4. Enter new magazine ID in the "Magazine ID" box.
5. Measure the feed lengths of prints 1 and 2 at the
center and record them.
6. Enter the feed lengths recorded in the "Print 1"
and "Print 2" boxes.
7. Click the [Set] button.
• Feed length is adjusted automatically.
8. Install the magazine in the upper deck to the lower
deck.
9. Repeat Steps 3 through 7 for the lower magazine.
10. Click the [Close] button.
• Operation returns to the menu screen.
<Manual Adjustment>
1. Enter the magazine ID to be adjusted in the
"Magazine ID" box.
2. Select "Upper deck" or "Lower deck".
3. Enter the value (mm) in the "New value" box.
Distributed by minilablaser.com
Print 1
5-95
5
Print 2