8.1 Light Source Section
8.1.1 Light Source Unit Removal/Reinstallation
Removal
1. Remove:
• Scanner section lower cover
.
(See Subsection 8.2.6)
• Front cover
(See Subsection 9.1.1)
2. Install the fixing bracket to conjugate length
variable section
(See Subsection 8.2.18)
3. Loosen the two screws and remove the light
source section cover.
4. Disconnect the three connectors from the CLE23
circuit board.
5. Remove the four screws and then the light source
unit.
Reinstallation
Reinstallation is essentially in the reverse order of
removal.
Distributed by minilablaser.com
.
.
8-3
Screws (2)
Light Source
Section Cover
CLE6
CLE1
CLE7
Connector
Connector
Connector
Screws (4)
Light Source Unit
Z2157
8
Z2158
Z2159