Chassis Intrusion Connector; Standby Power Led - DFI KS150-BT User Manual

Chassis Intrusion Connector

Chassis
Ground
Intrusion
2
1 Signal
The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
Chapter 5 Ports and Connectors
Chapter 5

Standby Power LED

This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
35
Standby Power LED
www.dfi .com