Chapter 9 - Digital I/O Programming Guide - DFI KS150-BT User Manual

15” touch panel pc
Hide thumbs Also See for KS150-BT:
Table of Contents

Advertisement

Chapter 9 - Digital I/O Programming Guide

Register Description
The Input P ort R egister (register 0) reflects the incoming logic lev els of the pins, regardless
of whether the pin if defined as an input or output by the Configur
only on the red oper ation. W rites to this register ha ve no ef fect. The def ault v alue (X) is de-
termined by the externally applied logic lev el. Bef ore a red oper ation, a write tr ansmission is
sent with the command byte to indicate to the I
accessed next.
Register 0 (Input P ort Register)
BIT
I-7
I-6
I-5
X
X
X
DEFAULT
The Onput P ort Register (register 1) shows the outgoing logic lev els of the pins defined as
outputs by the Configur ation Register. Bit v alues in this register ha ve no ef fect on pins defined
as inputs. In turns, reads from this register reflect the v alue that is in the flip-flop contolling
the output selection, not the actual pin v alue.
Register 1 (Onput P ort Register)
BIT
O-7
O-6
O-5
DEFAULT
1
1
1
The Polarity Inversion Register (register 2) allows polarit y inversion of the pins defined as
inputs by the Configur ation Register. If a bit in this register is set (writ ten with 1), the cor -
responding port pin's polarity is in verted. If a bit in this register is clear (writ ten with a 0), the
corresponding port pin's original polarit y is retained.
Register 2 (P olarity Inversion Register)
BIT
N-7
N-6
N-5
DEFAULT
0
0
0
Chapter 9 Digital I/O Progr amming Guide
ation R egister. They act
C device that the Input P ort R egiser will be
2
I-4
I-3
I-2
I-1
I-0
X
X
X
X
X
O-4
O-3
O-2
O-1
O-0
1
1
1
1
1
N-4
N-3
N-2
N-1
N-0
0
0
0
0
0
Chapter 9
The Configuration Register (register 3) configures the direction of the I/O pins. If a bit in this
register is set to 1, the corresponding port pin is enabled as an input with a high-impedence
output driver. If a bit in this register is cleared to 0, the corresponding port is enabled as an
input.
BIT
C-7
C-6
DEFAULT
1
1
71
Register 3 (Configur ation Register)
C-5
C-4
C-3
C-2
1
1
1
1
C-1
C-0
1
1
www.df .com

Advertisement

Table of Contents
loading

Table of Contents