Instructions For Use - Otto Bock 17B66-16 Instructions For Use Manual

► Please keep this document in a safe place.
These instructions for use provide you with important information on the pro­
cessing of the 17B66 ankle joints.
2 Product description
2.1 Available sizes
The bilateral system ankle joint is available in 2 versions supplied in pairs.
Joint bar connection
System width [mm]
2.2 Components/design
Item Component
1 Set screw
2 Truss head screw
3 Bearing nut
4 Upper joint section
The scope of delivery does NOT include:
Item Component
9 System lamination
bar
10 System foot stirrup
– System foot stirrup
– System foot stirrup
– System shoe stirrup
3 Application
3.1 Indications for use
The system ankle joints are intended to be used exclusively in pairs for the
fitting of lower limb orthoses for patients.
The manufacturer recommends that the system ankle joint be processed by
means of the lamination resin technique, thermoplastic technique or using
carbon prepreg technology.
17B66=*
Inside
16 20
Qua­ Item Component
ntity
4 5 Bearing ball
2 6 Stop pin (small)
2 7 Spring
2 8 Oval head screw
Article number
17Y128=16x80, =20x80
17B113
17B114
17B115
17B116
17B66=A*
Outside
16 20
Qua­
ntity
4
8
4
4
Ottobock | 9