Otto Bock 17B66-16 Instructions For Use Manual page 13

7 Maintenance
INFORMATION
The product may be exposed to increased loads by the patient.
► Shorten the maintenance intervals according to the expected loads.
The manufacturer requires at least a semi-annual inspection of the product
to verify functionality and check for wear.
Performing maintenance
► Lubricate the system ankle joints. Only use 633F7 special lubricant.
Individual spare parts and service set
Spare part
Set screw (1)
Truss head screw (2) 501S32=M6x14x10
Bearing nut (3)
Bearing ball (5)
Stop pin (6)
Spring (7)
8 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
8.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of
the product.
8.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
Single component
Article number
506G3=M6x6
17Y93=9x6.25xM6
509Y1=5.0
506A8=2.5x18
506A8=5x22
513D18=4.7x31
Service set
Quant­ Article number
ity
4 17B66=S
2
2
4
4
4
4
Ottobock | 13