Siemens HB34D552 Series Instruction Manual page 42

Problem
The appliance is not in
operation. A cooking time is p g
shown in the display
"F8" is shown in the display
¯
The indicator appears even
though the water tank is full g
¯
The indicator appears,
although the water tank is not
yet empty, or the water tank is
¯
empty but the indicator does
not appear
The water tank empties for no
discernible reason. The
evaporator dish overflows
The evaporator dish has boiled
empty even though the water p y g
tank is full
¯
The indicator appears
There is a "pop" noise during
cooking
42
All manuals and user guides at all-guides.com
Possible cause
A control knob was
unintentionally pressed
The Start button was not
pressed after the setting had
been made
Cleaning aid or descaling was
cancelled
The Automatic switch off is
active
The water tank has not been
pushed in properly
The detection system is not
working
The water tank is dirty. The
moving water level indicators
are jammed
The water tank was not closed
properly
The tank lid seal is dirty
The seal in the tank cover is
defective
The water tank has not been
pushed in properly
The feed line is blocked
The appliance has not been
used for at least 2 days and
the water tank is full
Cold/warm effect from frozen
food, caused by the steam
Notes/remedy
Press the Stop button
Press the Start button or delete
the setting with the Stop button
Turn the operating mode selector
to È or and rinse the
calc
appliance 2 times (see Section
Cancelling cleaning aid or
Cancelling descaling)
Press any button
Slide in the water tank until it
engages
Call the after sales service
Shake and clean the water tank.
If the parts cannot be released,
obtain a new water tank from the
after sales service.
Close the lid until you feel it
engage
Clean the seal
Obtain a new water tank from the
after sales service
Slide in the water tank until it
engages
Descale the appliance. Check
whether the water hardness range
is set correctly
Empty and clean the water tank.
Always empty the water tank after
cooking
This is normal