Basic Network Settings; Configuring The Dhcp - Yealink T5 Series User Manual

The phone status is displayed on the first page of the web user interface.
Note IPv6 is not available on all servers. Contact your system administrator for more information.

Basic Network Settings

In order to get your IP phones running, you must perform basic network setup. You can use
DHCP or configure a static address to connect your IP phone to the network. If your phone
cannot contact a DHCP server for any reason, you need to configure network settings manually.
The IP phone can support either or both IPv4 and IPv6 addresses.
Note The wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters, contact your
system administrator.

Configuring the DHCP

You can configure DHCP for IPv4 or IPv6. The following takes IPv4 as an example:
Procedure:
Navigate to Menu->Advanced (default password: admin) ->Network->WAN Port.
1.
Select IPv4 or IPv4 & IPv6 from the IP Mode field.
2.
Getting Started
29