Yealink SIP-T52S Quick Reference User Manual

How to (cont...):
CREATE A CONFERENCE CALL
1. Press the Conf soft key during an active call. The call is then placed on hold.
2. Enter the extension or external number of the second party, then press the Send soft key.
3. Press the Conf soft key again when the second party has answered the call.
• All parties are now joined in the conference call.
4. Press the EndCall soft key to disconnect all parties.
PLACE A CALL ON HOLD & THEN RESUME THE CALL
To place a call on hold:
1. Press the Hold soft key during an active call.
To resume a call from hold:
1. Press the Resume soft key when a call is on hold.
If there is more than 1 call on hold:
1. Press or to select the desired held call, then press
desired call.
ADD A NEW CONTACT
1. Press the Directory phone is idle, and then select All Contacts.
2. Tap Add.
3. Enter the contact's Name and Number.
4. Tap Save to accept the change.
MUTE OR UN-MUTE A CALL
1. Press to mute or un-mute an active call.
ACCESS VOICEMAIL
1. Press the Connect soft key or press
2. Follow the voice prompts to listen to your voice messages
3. To access another Extension's Voicemail, dial 778, enter the Extension number and its associated PIN
BARGE IN/LISTEN IN*
1. When Call Barge is enabled, a user can dial 88 followed by the extension number and be connected to an
active call.
• The following options are available when connected to an active call:
• Press 1 to speak to the call Receiver
• Press 2 to speak to the call Originator
• Press 3 to speak to both
• Press 0 to listen only
RECORD CALL*
1. When on an active call, press #8 to commence/end recording.
*Some features may require activation in your portal prior to use.
Page 4 | Copyright © Telair Pty Ltd (ABN 92 119 713 745) | www.telair.com.au | 1800 telair (835 247)
or press the Resume soft key to retrieve the
.
Yealink SIP-T52S
Media IP Phone
Quick Reference User Guide
Copyright © Telair Pty Ltd (ABN 92 119 713 745) | www.telair.com.au | 1800 telair (835 247)