Safety Requirements - Ametek Chandler Engineering 1910 Instruction Manual

Safety Requirements

READ BEFORE ATTEMPTING OPERATION OF INSTRUMENT
The Chandler Engineering Model 1910 Curing Chamber is designed for operator safety. Any
instrument that is capable of high temperatures should always be operated with CAUTION!!
To ensure safety:
 Locate the instrument in a low traffic area. Allow a minimum of 12 inches (305mm)
unobstructed clearance around side, back and top faces to provide for adequate
ventilation.
 Locate the instrument on a level surface to prevent involuntary movement.
 Always position the instrument in such a manner that allows easy access to the power
cord.
 Have the safety officer at your location or laboratory review the safety aspects of the
instrument and installation and approve the operational and installation procedures.
 Read and understand instructions before attempting instrument operation.
 Observe caution notes!
 Observe and follow the warning labels on the instrument.
 If the instrument is not used in accordance to this manual, the safety of the instrument
may be impaired.
 In case of malfunction, unplug power cords from the voltage source.
 Always disconnect main power to the instrument before attempting any repair.
 Never replace the power cord with an inadequately rated power cord.
 Post signs where the instrument is being operated to warn non-operating
personnel.
 Where appropriate PPE when operating the instrument especially in respect to fluids
being used.
 Appropriately rated fire extinguishers should be located within close proximity.
 Turn off the heater at completion of each test.
 As the top of the instrument gets hot during service it is not recommended that
top surface be obstructed.
 Avoid contact with moving parts.
 Never exceed the instrument maximum pressure and temperature ratings. The safety
requirements associated with the handling and use of the medium to be tested, especially
the additional requirements associated with handling potentially flammable liquids or
otherwise hazardous agents are the responsibility of the customer – proper precautions
must be taken to reduce the risk of fire or explosion.
 The swing arm's rotational radius is controlled by mechanical stops.
 Only use Chandler approved components.
PREFACE P-3