Ametek Chandler Engineering 1910 Instruction Manual page 20

Pressurized curing chamber

Table of Contents

2-8

SECTION 2 – OPERATION

Configure Indicators

This tab allows the operator to change the Name of the input, change the color of the Dial

Indicator on the Home Screen and calibrate the input. Select the appropriate indicator from

the list of indicators on the left. Our service department can perform a calibration procedure

using specialized instrumentation to assure that temperature drift and inaccuracies as a result

of time and usage are compensated for in order to keep your instrument compliant with API

specifications.

Configure Alarms

This tab allows the operator to configure Alarms. When configuring alarms, the following

should be considered:

 Temperature uses Input Signal TC1

 Wall Temperature uses Input Signal TC2

 Pressure uses Input Signal AI1

 Output DO2 controls the Pump (should be disabled on a High-Pressure Alarm)

 Output DO3 controls the Pressure Release

 Output GPO 0 controls the Heater Relay

 Output Relay 1 controls the Heater Contactor (Heater Soft key and Heater switch)

 PID 1 is the Temperature Control Loop

 PID 2 is the Pressure Control Loop

Table of Contents