Table of Contents
Advertisement
Empty the Chamber of Oil
1. Deactivate the Fill, Pump and Vent "Soft" keys; activate the Drain "Soft" Key. Wait
about two minutes for the chamber to empty, as indicated by air blowing into the oil
reservoir.
2. Deactivate the Drain "Soft" key.
3. Loosen the thermocouple nut and remove the thermocouple.
4. Open the chamber. Loosen the set screws and turn the seal shaft and plug
counterclockwise with the handles. Do not remove the ring.
Removing the Cylinder Plug
1. Hook the hoist to the cylinder plug hook and lift slowly.
2. Lower the plug using the hoist to a stable work platform.
3. Remove the hoist hook from the cylinder plug hook.
Remove the hoist Removing the Sample Rack
4. Hook the hoist to the sample rack and remove slowly.
5. Lower the hoist to a stable work platform.
6. Remove the hoist hook from the sample rack.
SECTION 2 – OPERATION
2-11
Advertisement
Table of Contents
