Britax Safe-N-Sound BS3700A-C20133 Series Instruction Manual page 15

SETUP - CLICKTIGHT FOR REARWARD FACING
Pull
7
8
28
Instructions for Installation & Use
Step 7. Remove any slack from the vehicle
seatbelt.
Feed sash belt slack back into the
seatbelt retractor.
ALWAYS REMOVE SLACK FROM
SEATBELT.
ENSURE THERE ARE NO TWISTS IN
SEATBELT.
Step 8. Always remove any excess shoulder/
lap straps, harness tongues and
harness adjuster strap (lower) that
may become trapped under the
CLICKTIGHT frame.
SETUP - CLICKTIGHT FOR REARWARD FACING
9
Push down
10
Lift
11
12
Step 9. Close CLICKTIGHT frame
Step 10. Press down until it locks into place.
If you need to apply excess force to
close the CLICKTIGHT frame, check
the shoulder/lap straps, harness
tongues and harness adjuster strap
(lower) are not trapped.
Step 11. Check if CLICKTIGHT frame is closed
by lifting the CLICKTIGHT FRAME up.
Your seat should feel secure.
Step 12. Refit infant insert as required.
You are now ready to install top tether.
Refer to page 30.
Instructions for Installation & Use
29