Britax Safe-N-Sound BS3700A-C20133 Series Instruction Manual page 37

INSTALLATION OF VEHICLE UPPER ANCHOR POINT
For vehicles other than Sedans - In Australia, consult your nearest child restraint fitting
station or traffic authority for vehicle inspection to find the best, correct position for the
placement of the upper anchorage point, and for the correct attachment bolt length and use
of spacers. In New Zealand, consult the agent for the vehicle. Note to Queensland purchases:
The installation of anchorage points must be approved by authorised officers appointed by
Queensland Transport. Authorised officers can be sourced from all Queensland Transport
Customer Service and Queensland Ambulance Service Centres.
NOTE: Marking on
the top of a Grade 5
Bolt. Do not use any bolt
without these marks.
200mm
min.
Centre line of
Fig.3.
seating position
72
Instructions for Installation & Use
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE
BOLT IS NOT THE CORRECT LENGTH THE
CAR MANUFACTURER'S HAND BOOK CAN
PROVIDE ADVICE ON THE CORRECT LENGTH
BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED
TO UNSOUND METAL OR TO WOOD, OR
SYNTHETIC STRUCTURES. WHEN DRILLING
9 MM HOLE DO NOT DRILL THROUGH FUEL
LINES, FUEL TANKS, ELECTRICAL WIRING, OR
RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED
FROM SHARP CORNERS AND EDGES. THE
ANCHOR FITTING MUST BE USED ONLY
AS DESCRIBED ABOVE. IT MUST NOT BE
HOOKED ONTO ANY OTHER OBJECT.
INSTALLATION OF VEHICLE UPPER ANCHOR POINT
CAR INSTALLATION ACCESSORIES
(From retailers of Britax Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038 or 0289
EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
Re-order no: 0035 or 0291 (length 300mm) or
0036 or 0290 (length 600mm)
73
Instructions for Installation & Use