AT Command Set
4.22 AT+CMEE Report mobile equipment error
Test command
AT+CMEE=?
Read command
AT+CMEE?
Write command
AT+CMEE=<n>
Example
Reference
GSM 07.07
TC3X_ATC_01_V04.00
Response
+CMEE: (list of supported <n>s ) OK
Parameter
See write command
Response
+CMEE: <n> OK
Parameter
See write command
This command controls the presentation of the result codes +CME
ERROR: <err> and CMS:<err> that indicate errors relating to ME
functionality.
When you power down or reset the ME with AT+CFUN=1,1 the setting will
be reset to its default. The levels 1 or 2 need to be selected every time
you reboot the ME, or may be included, for permanent use, in the user
profile saved with AT&W.
Response
OK
Parameter
0 disable result code (only 'ERROR' will be displayed)
<n>
1 enable result code and use numeric values
2 enable result code and use verbose values
To obtain enhanced error messages it is recommended to choose <n>=2.
AT+CMEE=2
OK
Note
· The possible error result codes are listed in chapter 7
· In multiplex mode (see "AT+CMUX Enter multiplex mode", pg. 86) the
setting applies only to the logical channel where selected. The setting
on the other channels may differ.
Page 84 of 204
29.05.2002