At+Fbadmul Error Threshold Multiplier; At+Fbor Query Data Bit Order - Siemens TC37 Module At Command Reference

AT Command Set

3.2 AT+FBADMUL Error Threshold Multiplier

Read command This command defines the "Copy-Quality-OK" multiplier. The number of lines
received with a bad pixel count is multiplied by this number. If the result
AT+FBADMUL?
exceeds the total number of lines on the page the error rate is considered too
high. A threshold multiplier value of 20 corresponds to a 5% error rate. A value
of 0 implies that error checking is not present or disabled.
Response
<badmul> OK
Parameter
See write command
Write command Response
OK
AT+FBADMUL=
<n>
If error is related to ME functionality:
ERROR
Parameter
<n>
Reference Note
EIA PN-2388 Used for Faxclass 2 only

3.3 AT+FBOR Query data bit order

Test command Query the bit order for receive-mode. The mode is set by the ME dependent on
the selected Service Class, see "AT+FCLASS Fax: Select, read or test service
AT+FBOR=?
class", pg. 45.
Response
(list of supported bit order modes <bor>s)
OK
Parameter
See write command
Read command Response
<bor> OK
AT+FBOR?
Parameter
See write command
Write command Response
OK
AT+FBOR=<bor>
Parameter
<bor>
Reference Note
EIA PN-2388 Used for Fax class 2 only
TC3X_ATC_01_V04.00
0 – 20 – 255
0 direct bit order for both Phase C and for Phase B/D data.
1 Reversed bit order for Phase C data, direct Bit Order for
Phase B/D data.
Page 44 of 204 29.05.2002