At+Fdcc Query Or Set Capabilities - Siemens TC37 Module At Command Reference

AT Command Set

3.8 AT+FDCC Query or set capabilities

Test command
AT+FDCC =?
Read command
AT+FDCC?
Write command
AT+FDCC=<VR>,
<BR>,<WD>,<LN>,
<DF>,<EC>,<BF>,
<ST>
Reference
EIA PN-2388
TC3X_ATC_01_V04.00
This command allows the connected application to sense and constrain the
capabilities of the facsimile DCE (=ME), from the choices defined in CCITT
T.30 Table 2.
Response
(list of <VR>s), (list of <BR>s), (list of <WD>s), (list of <LN>s), (list of <DF>s),
(list of <EC>s), (list of <BF>s), (list of <ST>s)
OK
Parameter
VR: Vertical Resolution, BR: Bit Rate, WD: Page Width, LN: Page Length, DF:
Data Compression Format, EC: Error Correction Mode, BF: Binary File
Transfer Mode, ST: Scan Time/Line.
For further information see AT+FDIS, pg. 49
Note:
Response
<dcc> OK
Parameter
See write command
Response
OK
Parameter
VR: Vertical Resolution, BR: Bit Rate, WD: Page Width, LN: Page Length, DF:
Data Compression Format, EC: Error Correction Mode, BF: Binary File
Transfer Mode, ST: Scan Time/Line.
: For further information see AT+FDIS, pg. 49
Note
Note
Used for Faxclass 2 only
Page 47 of 204 29.05.2002