AT Command Set
3.19 AT+FPHCTO DTE Phase C Response Timeout
Read command
The time-out value <tout> determines how long the DCE will wait for a command
after reaching the end of data when transmitting in Phase C. When time-out is
AT+FPHCTO?
reached, the DCE assumes that there are no more pages or documents to send.
Response
<tout> OK
Parameter
See write command
Write command
Parameter
AT+FPHCTO=
<tout>
<tout>
Response
OK
If error is related to ME functionality:
ERROR
Reference
Note
EIA PN-2388
Used for Fax class 2 only
3.20 AT+FREV Identify Product Revision
Test command
Sends the revision identification to the TA
AT+FREV?
Response
V2.550
OK
Reference
Note
Siemens
Used for Fax class 2 only
3.21 AT+FRH Receive Data Using HDLC Framing
Execute command
This command causes the TA to receive frames using the HDLC protocol and the
modulation defined below. An ERROR response code results if this command is
AT+FRH=<mod>
issued while the modem is on-hook.
Response
CONNECT
If error is related to ME functionality:
ERROR
Parameter
<mod>
Reference
Note
TIA/EIA-578
Used for Fax class 1 only
TC3X_ATC_01_V04.00
0 – 30 – 255
time-out value in 100ms units.
modulation mode
3
V21 Ch2
300 bps
24
V.27ter
2400 bps
48
V.27ter
4800 bps
72
V.29
7200 bps
96
V.29
9600 bps
Page 53 of 204
29.05.2002