At+Fcig Query Or Set The Local Polling Id; At+Fclass Fax: Select, Read Or Test Service Class - Siemens TC37 Module At Command Reference

AT Command Set

3.4 AT+FCIG Query or set the Local polling id

Test command Response
(max. length of Local Polling ID string) (range of supported ASCII character
AT+FCIG =?
values ) OK
Parameter
See write command
Read command Response
<id> OK
AT+FCIG?
Parameter
See write command
Write command Response
OK
AT+FCIG =<id>
Parameter
<id>
Reference Note
EIA PN-2388 See also "AT+FLID Query or set the Local Id setting capabilities", pg. 51.
Used for Faxclass 2 only

3.5 AT+FCLASS Fax: Select, read or test service class

Test command See introduction to fax commands, pg. 43.
AT+FCLASS=? Response
(list of supported <n>s)
OK
Parameter
See write command
Read command Response
<n> OK
AT+FCLASS?
Parameter
See write command
Write command The ME is set to a particular mode of operation (data, fax). This causes the MA
to process information in a manner suitable for that type of information.
AT+FCLASS=
<n> Response
OK
Parameter
<n>
Reference Note
EIA/TIA-592-A Using Error Correcting Mode (ECM) when sending FAXes over GSM should be
avoided.
TC3X_ATC_01_V04.00
Local Polling ID string, max. length and possible content as reported
by test command. Default value is empty string ("").
0 data (e.g. EIA/TIA-602 or ITU V.25ter)
1 Fax class 1 (EIA/TIA-578-A, Service Class 1)
2 Fax class 2 (EIA/TIA SP-2388, an early draft version of
EIA/TIA-592-A – Service class 2.1)
Page 45 of 204 29.05.2002