Table of Contents
Advertisement
Figure 1-40
Note
The SINAUT ST7cc for WinCC expansion packet is described in detail in a separate manual.
To complete the "Introduction to the SINAUT ST7 system" in this chapter, we will
nevertheless briefly outline the properties of the SINAUT ST7cc package.
For the manual see /4/ (Page 272).
1.9.2
The special properties of SINAUT ST7cc
Telecontrol master with user-friendly diagnostics
● Direct connection of SINAUT ST7 TIMs to ST7cc over MPI and Ethernet. A separate CPU
as telecontrol master is not required.
● Availability of the most important status information of each SINAUT subscriber with
visualization in WinCC using provided station typicals (picture typicals and faceplates)
● Option of controlling SINAUT subscribers with these faceplates
● Identification of process values from subscriber stations with a disrupted connection to
ST7cc
SINAUT ST7 station control system
System Manual, 09/2016, C79000-G8976-C178-10
SINAUT ST7cc control center system (single or redundant) with attached SINAUT
stations
Properties of the SINAUT components
1.9 SINAUT ST7cc, the add-on for WinCC
69
Advertisement
Table of Contents
