Table of Contents
Advertisement
Preface
To upgrade to this version, a full version of the SINAUT engineering software V5.0 must
be installed.
The engineering software V5.5 SP2 can be used with STEP 7 as of version V5.4 SP4.
To use the engineering software, a Windows operating system is required that is
compatible with the installed STEP 7 version.
You will find details on the ordering data and operating systems of the engineering
software in volume 2 of the system manual in the section SINAUT ST7 software: Ordering
data and compatible operating systems.
● Block library TD7onCPU
New version of the block library TD7onCPU V2.2 SP4 + Hotfix 1
– New block "FC-PathStatus" to display the main and substitute path to the remote
– The block library can now be used both in a standalone TIM in an S7-400 and an S7-
● TIM firmware
The new functions of the SINAUT engineering software named above are supported by
firmware version V2.5.4 for the following TIM modules:
TIM 3V-IE, TIM 3V-IE Advanced, TIM 4R-IE
Replaced documentation
This manual replaces the manual release 08/2011 (C79000-G89xx-C222-07).
For older releases of the manual, see below, section Version history (Page 7).
Purpose of the manual
The SINAUT ST7 system manual is split into two complementary volumes.
● Volume 1: System & Hardware
This documentation will support you on your way to successful application of SINAUT
ST7. This introduces you to the topic in clear and straightforward steps and provides you
with an overview of the hardware components of the SINAUT ST7 station control system.
You will be supported during the planning of network structures and topologies and will
see how to install and commission SINAUT components based on the installation
guidelines.
● Volume 2: Software
This documentation provides you with an overview of the software components of the
SINAUT ST7 station control system. You will see how individual components are
configured. Diagnostics and service options are also explained.
4
communications partner.
The block can be used as of version V5.5 SP1 of the engineering software and as of
TIM firmware V2.5.4.
400H also with only one single CPU (single mode).
SINAUT ST7 station control system
System Manual, 09/2016, C79000-G8976-C178-10
Advertisement
Table of Contents
