Table of Contents
Advertisement
Installing and putting a TIM into operation
4.2 Dimensions for installation of the SINAUT ST7 components
4.2
Dimensions for installation of the SINAUT ST7 components
Introduction
This section contains information on the dimensions for installing SINAUT ST7 components.
You will require this information when planning the mechanical layout of a SINAUT ST7
system.
Dimensions for installation of the components
Table 4- 2
Module
Communications module
TIM 3V-IE and
TIM 3V-IE Advanced
Communications module
TIM 4R-IE and TIM 4
Modem module
MD2, MD3 and MD4
4.3
Options for connecting up and settings for the TIM 4R or TIM 4RD
Introduction
The following paragraphs explain the connection options for the TIM 4R / TIM 4RD and the
location of the DIL switches with which you can make the hardware settings for the TIM.
In all the figures, the TIM is shown without front panels.
Note
Before you install a TIM module on the S7-300 rail, it is advisable to make all the required
settings for operation on all the DIL switches of the TIM. These switches are more accessible
when the module is not installed. If there is a DCF77 radio clock on the TIM, you should also
plug in the DCF77 adapter cable before installing the TIM.
122
Dimensions for installation of the SINAUT ST7 components
Module
width
40 mm
80 mm
80 mm
Module
Max. depth
height
125 mm
120 mm or 150 mm with
open front panel
125 mm
120 mm or 180 mm with
open front panel
125 mm
120 mm or 180 mm with
open front panel
SINAUT ST7 station control system
System Manual, 09/2016, C79000-G8976-C178-10
Installation
on
S7 rail
S7 rail
S7 rail
Advertisement
Table of Contents
