Installation and commissioning of the modems and routers
5.7 Analog dial-up modem MD3
4. Power supply OFF, set switch SW2.7 to OFF
5. Select the basic setting and standard profile and turn the power supply ON
Figure 5-32
Default settings of the DIL switches SW1 and SW2
When it ships, the modem has the following default settings:
● Metering pulse filter 16 kHz
● Loop power section activated
● Standard dialing profile 0: AT mode
● Data format 11 bits (8E1)
● Tone dialing
● Loudspeaker OFF
● Line adjustment Zr
When shipped, the switches are set as shown in the following figure.
Figure 5-33
202
Setting the DIL switch for a modem reset
Default settings of the DIL switches SW1 and SW2
SINAUT ST7 station control system
System Manual, 09/2016, C79000-G8976-C178-10