I_Apci1500_Initwatchdogcounter3 - Addi-Data ADDINUM CPCI-1500 Technical Description

Technical description

4) i_APCI1500_InitWatchdogCounter3 (...)

Syntax:
<Return value> = i_APCI1500_InitWatchdogCounter3
Parameters:
BYTE
BYTE
LONG
BYTE
BYTE
BYTE
Chapter 9
b_BoardHandle
b_WatchdogOrCounterSelect
l_ReloadValue
b_ContinuousOrSingleCycleSelect
b_HardwareOrSoftwareGateSelect
b_InterruptHandling
(BYTE b_BoardHandle,
BYTE b_WatchdogOrCounterSelect,
LONG l_ReloadValue,
BYTE b_ContinuousOrSingleCycleSelect,
BYTE b_HardwareOrSoftwareGateSelect,
BYTE b_InterruptHandling)
Handle of the xPCI-1500
Selects the mode of the third
counter/watchdog
- APCI1500_WATCHDOG :
The third counter/watchdog is used as a
watchdog.
- APCI1500_COUNTER :
The third counter/watchdog is used as a
counter.
This parameter has 2 meanings.
If the counter/watchdog is used as a
counter, it loads the limit value of the
counter.
If the counter/watchdog is used as a
watchdog, it loads the watchdog time.
- APCI1500_CONTINUOUS:
Each time the counting or timer value
is set to "0", l_ReloadValue is loaded.
- APCI1500_SINGLE:
If the counter or timer value is set to
"0", the counter or timer is stopped.
- APCI1500_HARDWARE_GATE
Input 16 is used for the gate.
- APCI1500_SOFTWARE_GATE:
Input 16 has no influence on the gate.
Interrupts can be generated, when the
counter or watchdog has run down.
With this parameter the user
decides to use interrupts or not.
- APCI1500_ENABLE:
Interrupts are enabled.
- APCI1500_DISABLE:
Interrupts are disabled.
APCI-/CPCI-1500
87