I_Apci1500_Inittimercounter2 - Addi-Data ADDINUM CPCI-1500 Technical Description

Technical description

3) i_APCI1500_InitTimerCounter2 (...)

Syntax:
<Return value> = i_APCI1500_InitTimerCounter2
Parameters:
BYTE
BYTE
LONG
BYTE
BYTE
BYTE
Chapter 9
b_BoardHandle
b_CounterOrTimerSelect
l_ReloadValue
b_ContinuousOrSingleCycleSelect: - APCI1500_CONTINUOUS:
b_HardwareOrSoftwareTriggerSelect:
b_HardwareOrSoftwareGateSelect :
(BYTE b_BoardHandle,
BYTE b_CounterOrTimerSelect,
LONG l_ReloadValue,
BYTE b_ContinuousOrSingleCycleSelect,
BYTE b_HardwareOrSoftwareTriggerSelect,
BYTE b_HardwareOrSoftwareGateSelect,
BYTE b_InterruptHandling)
Handle of the xPCI-1500
Selects the mode of the 2
- APCI1500_TIMER :
The 2nd counter/timer is used as a timer
- APCI1500_COUNTER :
The 2nd counter/timer is used as a counter
This parameter has two meanings.
If the counter/timer is used as a counter, it
loads the start value of the counter.
If the counter/timer is used as a timer,
it loads the divider factor for the output.
Each time the counter value or timer value
is set to "0", l_ReloadValue is loaded.
- APCI1500_SINGLE:
If the counter or timer value is set to
"0", the counter or timer is stopped.
- APCI1500_HARDWARE_TRIGGER:
The input 12 is used for the trigger.
If this input channel is on high, the
start value is re-loaded.
- APCI1500_SOFTWARE_TRIGGER:
Input 12 has no influence on the trigger
- APCI1500_HARDWARE_GATE:
The input 13 is used for the gate.
If this input channel is on high, the
counter/timer is started.
If this input channel is on low,
the counter/timer is stopped.
- APCI1500_SOFTWARE_GATE:
Input 13 has no influence on the gate.
APCI-/CPCI-1500
nd
counter/timer
85