SIRIUS 3RV2 motor starter protectors
4.9 Accessories
4.9.4.2
Mounting
Mounting signaling switches
Table 4- 13
Step
1
2
3
4
Reference
More information ...
About connection
4.9.4.3
Disassembly
Disassembling signaling switches
Table 4- 14
Step
1
2
3
414
Mounting a signaling switch
Operating instruction
Press and hold down the transport
lock on the inside of the signaling
switch.
Then also press the blue RESET
button on the front of the signaling
switch until it engages.
Attach the signaling switch to the rear
of the motor starter protector.
Press the signaling switch to the
motor starter protector until you hear
it engage.
Disassembling a signaling switch
Operating instruction
Press the clips on the top and bottom
of the signaling switch together.
Run a screwdriver between the motor
starter protector and the signaling
switch. Dislodge the signaling switch
from the motor starter protector by
carefully turning the screwdriver.
Remove the signaling switch from the
side of the motor starter protector.
Figure
Is available in ...
the chapter titled Circuit diagrams (Page 482)
Figure
System Manual, 01/2011, A8E56203870002-03
SIRIUS Innovations