Table of Contents
Advertisement
Besides the 10/100/1000Base-T RJ-45 ports, the Z9264F-ON switch provides several ports for management and storage.
NOTE:
The output examples in this section are for reference only. Your output may vary.
Topics:
•
RS-232 console port access
•
MicroUSB-B console port access
•
USB storage mount
•
Before you install an OS
•
ONIE service discovery
RS-232 console port access
The RS-232 console port is on the I/O-side of the Z9264F-ON switch.
Figure 19. Z9264F-ON RS-232 console and management ports
•
1—RS-232 console port (top), RS-232 management port (bottom)
CAUTION:
Ensure that any equipment that is attached to the serial port can support the required 115200 baud rate.
NOTE:
Before starting this procedure, ensure that your computer has a 9-pin serial port and that you have installed a terminal
emulation program on your computer.
NOTE:
If the serial port on your computer cannot accept a female DB-9 connector, use a DB-9 male-to-male adaptor.
1
Install the provided RJ-45 connector-side of the provided cable into the switch console port.
2
Install the DB-9 female-side of the provided copper cable into the serial port on your computer.
Alternatively, install the DB-9 cable into other data terminal equipment (DTE) server hardware.
3
Keep the default terminal settings on the console as follows:
•
115200 baud rate
•
No parity
•
Eight data bits
34
Management ports
Management ports
8
Advertisement
Table of Contents
