Table of Contents
Advertisement
NBP 1200C • Setup Guide (Continued)
Americans with Disabilities Act (ADA) compliance
When planning where to install the NBP button panels, you may need to consider factors affecting accessibility of the button
panels such as height from the floor, distance from obstructions, and how far a user must reach to press the buttons. For
guidelines, see sections 307 ("Protruding Objects") and 308 ("Reach Ranges") of the 2010 ADA Standards for Accessible Design
available at http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf.
Included parts
1 1
1
1
1 1
1
Figure 1.
NBP 1200C Included Parts
Item
NBP 1200C
1
Connectivity bracket
2
AAP frame plate
3
Cable grommet plate
4
Retractor bracket
5
NOTE:
*A single connectivity bracket is provided. It can be used with either the AAP frame plate or the cable grommet plate.
Step 2: Prepare the Installation Site, Cut the Table or Furniture
ATTENTION:
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé uniquement.
•
If the NBP will be installed into fine furniture, it is best to hire a licensed, bonded craftsperson to cut the access hole and
•
perform the physical installation so the surface will not be damaged.
S'il est prévu d'installer le NBP dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et qualifié pour
•
couper le trou d'accès et réaliser l'installation de telle façon que la surface ne soit pas endommagée.
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s'appliquent au site de l'installation.
•
Site preparation
To prepare the site:
Decide on the method for cutting a hole in the table (see the next page).
1.
Obtain the cut-out template. Verify that you have the correct cut-out template and dimensions (see the next page).
2.
Protect the surface prior to and during cutting so the surface is not damaged.
3.
2
2
2
2
2
2
2 2
2
2 2
2
Qty
Item
1
Retractor pin and clip
6
1*
6 pan-head mounting screws
7
and star washers
1
1
4-40 module screws
8
1
3 3
5
5
5
5
5
5 5
5
5
5
5 5
6 6
Qty
1
Hole plugs
9
8
Extron removal tool (not shown)
8
Extron Tweeker (small
screwdriver) (not shown)
Blank buttons (not shown)
4 4
7 7
8 8
9 9
Item
Qty
6 (3/8")
2 (1/4")
1
1
1
Advertisement
Table of Contents
