Parameters - Danfoss VLT FC 100 Series Manual

FC 100/ 200/ 300 DeviceNet

6. Parameters

8-01 Control Site
Option:
*
[0]
[1]
[2]
The setting in this parameter overrides the settings in par. 8-50 to 8-56.
8-02 Control Word Source
Option:
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[30]
8-03 Control Word Timeout Time
Range:
*
1.0s
8-04 Control Word Timeout Function
Option:
*
[0]
[1]
[2]
Function:
Digital and ctrl. word Control by using both digital input and control word.
Digital only Control by using digital inputs only.
Control word only Control by using control word only.
Function:
None
FC RS485
FC USB
Option A
Option B
Option C0
Option C1
External Can Select the source of the control word: one of two serial interfa-
ces or four installed options. During initial power-up, the fre-
quency converter automatically sets this parameter to
A
[3] if it detects a valid fieldbus option installed in slot A. If the
option is removed, the frequency converter detects a change in
the configuration, sets par. 8-02 back to default setting
RS485
installed after initial power-up, the setting of par. 8-02 will not
change but the frequency converter will trip and display: Alarm
Option Changed
67
This parameter cannot be adjusted while the motor is running.
Function:
[0.1 - 18000.0 s] Enter the maximum time expected to pass between the recep-
tion of two consecutive telegrams. If this time is exceeded, it
indicates that the serial communication has stopped. The func-
tion selected in par. 8-04
then be carried out. The time-out counter is triggered by a valid
control word.
Function:
Off
Freeze Output
Stop
MG.33.D3.02 - VLT ® is a registered Danfoss trademark
, and the frequency converter then trips. If an option is
.
Control Word Time-out Function
6. Parameters
6
Option
FC
will
53