Assumptions; Hardware; Background Knowledge - Danfoss VLT FC 100 Series Manual

Devicenet

Hide thumbs Also See for VLT FC 100 Series:

Table of Contents

FC 100/ 200/ 300 DeviceNet

Illustration 1.1: Topology

1.5. Assumptions

These operating instructions assume that you are using a Danfoss FC 100, 200 or 300 frequency

converter with DeviceNet. It is also assumed that as master you are using a PLC or PC equipped

with a serial communication card supporting all the DeviceNet communication services required

by your application. Furthermore, it is assumed that all requirements stipulated in the DeviceNet

standard as well as those set up in the AC Drive Profile and those pertaining to the VLT frequency

converter are strictly observed as well as all limitations therein fully respected.

These operating instructions relate to the DeviceNet option type no. 130B1102 and 130B1201.

The Danfoss DeviceNet is designed to communicate with any master abiding by the DeviceNet

standard. It is therefore assumed that you have full knowledge of the PC or PLC you intend to use

as a master in your system. Any questions pertaining to hardware or software produced by any

other manufacturer is beyond the scope of these operating instructions and is of no concern to

Danfoss. If you have questions about how to set up master - master communication or commu-

nication to a non-Danfoss slave, please consult the appropriate documentation.

MG.33.D3.02 - VLT

is a registered Danfoss trademark

1. Introduction

Table of Contents

Do you have a question about the VLT FC 100 Series and is the answer not in the manual?

Vlt fc 300 series Vlt fc 200 series