Preliminary Work; Heater Installation Location - Webasto Thermo Top Evo Installation Documentation

Audi A4 / A5

Preliminary Work

Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Disconnect the battery.
• Remove the coolant reservoir cap.
• Remove the air filter box.
• Remove the right front wheel.
• Remove wheel-well inner panel on the right-hand side.
• Remove the front underride protection.
• Remove the underride protection on the right-hand side of the fuel line.
• Remove the rear right underride protection.
• Remove the rear bench seat.
• Remove the glove compartment (see installation instructions).
• Remove the side trim on the right-hand side of the A-pillar.
• Remove the loudspeaker cover on the right side of the instrument panel (only in case of Telestart).
• Remove the A/C control panel (see installation instructions).
Heater
- Remove years that do not apply from the type and duplicate label.
- Attach the duplicate label (type label) visibly in the appropriate place in the engine compartment.
Ident. No.: 1318638A_EN

Heater Installation Location

1
1 Heater
1
Status: 24.09.2012
Installation
location
© Webasto Thermo & Comfort SE 5