Preliminary Work; Heater Installation Location - Webasto Thermo Top Evo Installation Documentation

Skoda Roomster

Preliminary Work

Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Completely remove the battery.
• Remove the battery carrier.
• Remove the windscreen wiper.
• Remove the coolant reservoir cap.
• Loosen the front partition wall of the coolant reservoir on the left.
• Remove the underride protection.
• Remove the left-hand wheel well trim.
• Fold up the rear bench seat surface.
• Open the tank-fitting service lid.
• Remove the fuel-tank sending unit in accordance with the manufacturer's instructions.
• Remove the radio (only with Climatronic).
• Remove the A/C control panel (only with Climatronic), screw fitting 2x under the control panel.
• Remove the lower trim of the instrument panel on the driver's side.
• Remove the side cover of the instrument panel on the left (only with Telestart).
• Detach the central electrical box in the passenger compartment.
• Drain the engine coolant according to the manufacturer's instructions.
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) in the appropriate place in the engine compartment.
1316415C_EN

Heater Installation Location

1 Heater
1
1
Installation
location
5