Kia Rio
Preliminary Work
Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
• Depressurise the cooling system.
• Remove the air filter completely, together with the intake hose.
• Disconnect and completely remove the battery together with the carrier.
• Remove the engine control unit.
• Remove the cover of the fuse and relay box in the engine compartment.
• Remove the left underride protection.
• Remove the left front wheel.
• Remove the left front wheel well trim.
• Remove the rear bench seat.
• Open the tank-fitting service lid.
• Remove the lower instrument panel trim on the driver's side.
• Remove the A/C control panel (only with automatic air-conditioning).
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) visibly in the appropriate place in the engine compart-
ment.
Ident. No.: 1318004J_EN
1
Status: 30.03.2016
Heater Installation Location
1 Heater
1
© Webasto Thermo & Comfort SE
Installation
location
5