Honeywell Home THX9321 Prestige 2.0 Manual page 49

ISU Installer Setup
Number Name
50° F to 70° F
6040 Remote Setback -
Standby Heat
Setpoint
None
6050 What Terminals are
S1
Wired to the Full
Drain Pan Alert Dry
S2
Contact?
S3
S4
Normally Open
6060 Full Drain Pan Alert
Dry Contact Setup Normally Closed
None
6070 What Terminals are
S1
Wired to the Dirty
Filter Alert Dry
S2
Contact?
S3
S4
Normally Open
6080 Dirty Filter Alert Dry
Contact Setup Normally Closed
None
6090 What Terminals are
S1
Wired to the Water
Leak Alert Dry
S2
Contact?
S3
S4
THX9321 PRESTIGE
Table 4. Installer Setup (ISU) Table. (Continued)
Settings Default
64° F
None
Normally Open
None
Normally Open
None
49
®
2.0 AND THX9421 PRESTIGE
Residential,
Commercial Requires
or Both EIM
Commercial Yes Remote Setback requires an EIM (Equipment
Interface Module).
During occupied periods, the occupancy sensor
tells the thermostat to go to STANDBY (setback
settings) when no one is in the room. If
someone is in the room, then it follows the
settings of the occupied period. The occupancy
sensor is ignored during unoccupied periods.
If the thermostat is setup for non-
programmable, the occupancy sensor tells the
thermostat to go to STANDBY settings when no
one is in the room. If someone is in the room,
then it follows the settings set by the user.
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
Choose an option appropriate for the type of
device installed.
Normally Open: The Dry Contact device is
normally open and will close when the device
detects the drain pan is full.
Normally Closed: The Dry Contact device is
normally closed and will open when the device
detects the drain pan is full.
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
Choose an option appropriate for the type of
device installed:
Normally Open: The Dry Contact device is
normally open and will close when the device
detects a dirty filter.
Normally Closed: The Dry Contact device is
normally closed and will open when the device
detects a dirty filter.
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
®
IAQ WITH EIM
Notes
68-0311—08