Honeywell Home THX9321 Prestige 2.0 Manual page 125

2. Select the terminals wired to the Remote Setback Dry
Contact device (occupancy sensor) and press Next.
Fig. 306.
3. Select Normally Open when Occupied or Normally
Closed when Occupied based on the type of dry con-
tact device installed.
NOTE: Normally Open when Occupied: The Dry
Contact device is open when the room is
occupied and will close when the room is
unoccupied.
Normally Closed when Occupied: The Dry
Contact device is closed when the room is
occupied and will open when the room is
unoccupied.
Fig. 307.
®
THX9321 PRESTIGE 2.0 AND THX9421 PRESTIGE
4. Select a Remote Setback Time Delay. The Remote
Setback Time Delay forces the thermostat to wait
before it switches from occupied settings to the
standby settings. When set to 0 minutes, the thermo-
stat will switch from occupied settings to the standby
settings immediately when the room is unoccupied.
5. Select the Standby settings that you would like to
maintain when the occupancy sensor detects the
room is unoccupied.
125
®
IAQ WITH EIM
Fig. 308.
Fig. 309.
68-0311—08