Specifications - Cisco 4G-ANTM-OM-CM Manual

Cisco Indoor/Outdoor Active GPS Antenna (GPS-ACT-ANTM-SMA)

Specifications

Figure 1 Specifications for the Cisco GPS-ACT-ANTM-SMA Antenna
Specification
Maximum RF input power
Power Supply
Amplifier Gain
Amplifier Filter Topology
Connector
VSWR
Noise Figure
Amplifier Filter Topology
Characteristic impedance
Antenna base and radome color
Antenna dimensions
Operating temperature
Operating frequency ranges
Polarization
Maximum peak gain (at Boresight)
Shocks
Drop test
Cable Length
Mount Bracket
Anchor
Screws
1. VSWR = voltage standing wave ratio.
2. RHCP = right hand circularly polarized.
1
Description
1 W
3-5VDC,
20mA typical @3V
30mA typical @5V
27dB typical @25C
Antenna-LNA1-BPF1-LNA2-cable-SMA(m)
connector.
Due to a topology without front end filter
immediately following the antenna, antenna has
the benefit of lower noise figure, but may not be
suitable for collocation with a high power wireless
transceiver.
SMA male
2:1 or less
1.5dB typical @25C
Antenna-LNA1-BPF1-LNA2-cable-SMA(m)
connector.
Due to a topology without front end filter
immediately following the antenna, the antenna
has the benefit of a lower noise figure, but may not
be suitable for collocation with a high power
wireless transceiver.
50 Ohm
Black
1.7 (L) x 1.4 (W) x 0.55 (H) in.
(44 x 36 x 14mm)
–40° to 185°F (–40° to 85°C)
1574.42-1576.42 MHz
2
RHCP
4 dBic
50G
10x3 axis / 1 meter drop 6 axis
17 foot (5.18 meters)
Metal
1 inch. The anchor drill size is 3/16.
3 stainless-steel screws that are self-drilling pan
head #2 Phillips.
497