Mounting The Cisco Active Gps Antenna With The Bracket - Cisco 4G-ANTM-OM-CM Manual

Cisco Indoor/Outdoor Active GPS Antenna (GPS-ACT-ANTM-SMA)

Mounting the Cisco Active GPS Antenna With the Bracket

1. Use the supplied metal bracket, screws and wall anchors (if necessary) to mount the antenna to a wall, as shown in
2. Insert the cable through the hole on top of the bracket and seat the antenna radome on the bracket as shown in
Figure 3 Attaching the Antenna Wall-mount
Obtaining Documentation and Submitting a Service Request
For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly
What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Subscribe to the What's New in Cisco Product Documentation as an RSS feed and set content to be delivered directly to your
desktop using a reader application. The RSS feeds are a free service. Cisco currently supports RSS Version 2.0.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL:
www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship
between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output,
network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative
content is unintentional and coincidental.
4
1
2
499
Figure
Figure
3
3.
3.