Cisco 4G-ANTM-OM-CM Manual page 206

Cisco Aironet 2.4 GHz and 5 GHz Dual-Band Polarization-Diverse Directional Array Antenna (AIR-ANT2566D4M-R)
7. After the antenna is secured on the mast, adjust the azimuth (side-to-side position) and elevation (up-and-down position)
of the antenna. Loosen the adjustment pivot bolts slightly to allow for adjustment.
Azimuth angle can be adjusted ±90 degrees
You can use the azimuth and elevation markings on the articulating mounting arm and the flange brackets as a guide. See
Figure 6.
8. After you adjust the antenna position, tighten the adjustment bolts. Tighten all the bolts to not more than 30 lbf.in. (3.4 Nm).
9. Connect the antenna cables to the access point. The antenna ports are labeled A through D. Connect the antenna port A
to connector A on the access point, antenna port B to connector B on the access point, and so on.
For the recommended cable type, see
Figure 9 Antenna Bracket Hose Clamp Assembly for Pole Mounting
1 Articulating mount flange attached to the back of the
antenna.
2 Articulating mount arm.
3 Articulating mount flange that is fastened to the pole or
mast using hose clamps.
(Figure 7) and elevation can be adjusted ±55 degrees
Recommended Cable.
5
4
5
482
1
2
Worm-gear-type hose clamp (50–135mm) for mounting
the assembly on a pole or mast.
Cables connecting the antenna to an access point.
(Figure 8).
3
4