Mounting The Antenna - Cisco 4G-ANTM-OM-CM Manual

Industrial routers and industrial wireless access points antenna
Hide thumbs Also See for 4G-ANTM-OM-CM:
Table of Contents

Advertisement

Cisco Multiband Panel Outdoor 4G MIMO Antenna (ANT-4G-PNL-OUT-N)

Mounting the Antenna

Follow these instructions to mount the antenna:
1.
Mark the desired location where you plan to mount the antenna and create a hole to receive the antenna.
NOTE: The rubber washer is not required for ceiling tile installations.
2.
Make sure that the antenna is properly positioned, then tighten the washer and plastic nut to secure the antenna.
Connecting the Lightning Arrestor
To install a lightning-protection device, please refer to the appropriate Hardware Installation Procedures for the model of
hardware you are installing. Links to hardware installation guides and other information may be found in
Information".
Connecting the Antenna to the Router
To attach the router-end of the cable to your device, please refer to the appropriate Hardware Installation Procedures for the
model of hardware you are installing. Links to hardware installation guides and other information may be found in
"Additional
Information".
NOTE: Coaxial cable loses efficiency as the frequency increases, resulting in signal loss. The cable should be kept as short as
possible because cable length also determines the amount of signal loss—the longer the cable length or run, the greater the
loss).
Obtaining Documentation and Submitting a Service Request
For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly
What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Subscribe to the What's New in Cisco Product Documentation as an RSS (Really Simple Syndication) feed, and set it so content
is delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports
RSS Version 2.0.
Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at
www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship
between Cisco and any other company. (1005R)
368
Chapter 1, "Additional
Chapter 1,

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents